How can a redox reaction be identified?
O A. Atoms have rearranged.
O B. Protons have been transferred.
.
O
C. lons are present in solution.
D. Oxidation states have changed.

Answer:

Boyle's Law: When the pressure of a gas increases, the volume of the gas will decrease as long as the temperature and amount of gas are constant.

So basically pressure is inversely proportional to Volume, when one increases, the other decreases, vice versa.

Equation: [tex]P_{1} V_{1} = P_{2} V_{2}[/tex]

Charles Law: When the temperature of a gas increases, the volume of a gas will also increase if the pressure and amount of gas are constant.

So basically Temperature and volume are directly proportional.

Equation: [tex]\frac{V_{1}}{T_{1}} = \frac{V_{2} }{T_{2} }[/tex]

Gay Lussac's Law: When the temperature of a gas increases, the pressure of a gas also increases when volume and the amount of gas remain constant.

Basically, Temperature and Pressure are directly proportional.

Equation: [tex]\frac{P_{1}}{T_{1}} = \frac{P_{2} }{T_{2} }[/tex]

Avogadro's Law: The most intuitive gas law. When you increase the amount of gas, the volume will also increase.

Meaning the moles (amount of gas) is directly proportional to volume.

Equation: [tex]\frac{V_{1} }{n_{1} } = \frac{V_{2} }{n_{2} }[/tex] (n stands for moles)

There is a combined gas law and ideal gas law but those are just the gas laws mentioned above but combined together. These should be everything.

Answer:

Boyle Law is when pressure and volume have a reverse relationship when temperature is the same.Charles law is basically when volume and temperature have a relationship when the pressure is the same.Lussac Law is I think just when I pressure and temperature is directly tied together when the volume stays the same.I dont think there is any "avogadro law", there is only pressure volume and temperature.

Please give brainliest thanks :D

Answer:

the clay will be melted by the light

Explanation:

because UV rays are hot but in a way, human skin can not feal pain

Answer:

Normal Fault -> Tension

Reverse Fault -> Compression

Strike-Slip Fault -> Shearing

Explanation:

Normal Fault -> Tension

[] A normal fault is when the walls are being pulled apart and is caused by tension

[] Example:

         <-       ->

Reverse Fault -> Compression

[] A reverse fault is when the walls are being pushed together and is caused by compression

[] Example:

         ->        <-

Strike-Slip Fault -> Shearing

[] A strike-slip fault is when the walls are being pushed apart in parallel directions and is caused by shearing

[] Example:

         /\         \/

Note: The page you provided also gives the answers for this specific question.

Have a nice day!

     I hope this is what you are looking for, but if not - comment! I will edit and update my answer accordingly. (ノ^∇^)

- Heather

Answer:

intra moleculer force is the force which you can't see

Answer:

Ground state

the state with the smallest amount of energy.

Answer:

The speed of light, c, equals the wavelength, λ (pronounced lambda), times the frequency, ν, (pronounced noo).

c=λν

c is a constant. It is usually given as 3.00×108 m/s or 3.00×1010 cm/s rounded to three significant figures.❤

The pressure of the gas when the volume of the vessel is tripled is 0.50 atm.

To find the volume of the gas, we use Boyle's law which states that for a given mass of gas at constant temperature, the pressure is inveresly proportional to its volume. This is stated mathematically as P ∝ 1/V.

So, PV = constant

P₁V₁ = P₂V₂ where P₁ = initial pressure of gas = 1.50 atm, P₂ = final pressure of gas, V₁ = initial volume of gas = 78.00 L and V₂ = final volume of gas = 3V₁ (since the volume of the gas is tripled)

So, making P₂ the subject of the formula, we have

P₂ = P₁V₁/V₂

Substituting the values of the variables into the equation, we have

P₂ = P₁V₁/V₂

P₂ = 1.50 atm × V₁/3V₁

P₂ = 1.50 atm/3

P₂ = 0.50 atm

So, the pressure of the gas when the volume of the vessel is tripled is 0.50 atm.

Learn more about Boyle's law here:

https://brainly.com/question/25736513

I belive that your answer would be False

flowering plants are called?

Angiosperms

Angiosperms are plants that bloom and bear fruit. The word angiosperm is derived from two Greek words, Angeion and Sperma . Angeion means "vessel" and sperma means "seed".

Answer:

the answer is A because the rest wouldnt go good with the work

Explanation:

Answer:

universal waste

hope it helps

Answer:

1. Rutherford performs the gold foil experiment while JJ Thompson performs cathode ray experiment. It was Rutherford's experiment that used positively charged alpha particles (He with a +2 charge) that were deflected by the dense inner mass of the nucleus (nucleus). The conclusion that could be drawn from this finding was that atoms were composed of an inner core that comprised the majority of the atom's mass and was positively charged in nature. The work of JJ Thompson using cathode ray tubes demonstrated that all atoms contain small negatively charged subatomic particles, also known as electrons. According to Thomson's conception of the atom, which had negatively-charged electrons buried inside a positively-charged "soup," the atom was made of plum pudding. Protons, electrons, and neutrons are the three fundamental particles that make up an atom. The protons (which are positively charged) and neutrons (which are neutrally charged) are found in the nucleus (center) of an atom (no charge). The electrons are contained inside the electron shells, which are the outermost parts of the atom (negatively charged).

2. Given that the frequency is 1/T, the equation linking wave speed, frequency, and wavelength is v=f t. The relationship between frequency and wavelength is inversely proportional. The wavelength of the wave with the highest frequency is also the shortest. When the frequency is doubled, the wavelength is cut in half. As a result, the wavelength to frequency ratio is the inverse of the frequency to wavelength ratio. When it comes to carrying energy, the frequency and amplitude of the waves are important factors to consider. The higher the frequency, the greater the amount of energy, and the larger the amplitude, the greater the amount of energy.

3. There are four shells that scientists used. First shell contains 2 electrons. Second shell consists of 8 electrons. Third shell has 18 electrons. Lastly, fourth shell has 32 electrons. 2 electrons can fit into each shell. If you want to compute an electron configuration, first split the periodic table into portions that represent the atomic orbitals, which are the locations where electrons are found. The s-block is represented by groups one and two, the d-block by groups three through twelve, the p-block by groups thirteen through eighteen, and the f-block by the two rows at the bottom.

Explanation:

That's the three questions I chose to answer. Hope it helps;)

Answer:

corbonization for dictionnal

Explanation:

correct

Answer:

neutralization reaction forms water and salt , neutralization is the reaction!

Explanation:

Answer:

If you are looking for the answer, for the question.

Earthquakes trigger tsunamis when the seismic activity causes the land along fault lines to move up or down

The volume of precipitating reagent, HCl required to precipitate silver in the form of AgCl from 2,000 g of an alloy containing 22% by weight of Ag is 0.530 L

In order to determine the volume of precipitating reagent, HCl required to precipitate silver in the form of AgCl from 2,000 g of an alloy containing 22% by weight of Ag, the following steps are followed:

Step 1.

The concentration of the HCl solution is calculated using the formula:

Percentage purity of HCl = 36% = 0.36

specific gravity, r = 1.17 g/cm³

molar mass of HCl = 36.5 g/mol

Concentration of HCl = 0.36 * 1.17 * 1000 / 36.5 * 1

Concentration of HCl = 11.53 mol/L

Therefore, 1 L of HCl solution contains 11.53 moles of HCl

Step 2:

The equation of the dissociation of HCl solution is given below:

1 mole of HCl produces 1 mole of Chloride ions, Cl⁻

Equation of reaction between Silver in the alloy and HCl is given as follows:

A white precipitate of AgCl is formed but hydrogen gas is not formed as Silver is a less reactive metal.

1 mole of HCl produces 1 mole of Cl⁻ which reacts with 1 mole of Ag to produce 1 mole of AgCl precipitate.

Step 3: Determine the mass and number of moles of silver in the alloy

Mass of silver in 2000 g alloy = 0.22 * 2000 g

Mass of silver in 2000 g alloy = 440 g

Number of moles of silver in 440 g of silver is determined using the formula below:

molar mass of silver = 108 g/mol

number of moles of silver = 440 /108

number of moles of silver in the alloy = 4.074 moles

Step 4: Calculate the volume of HCl required

Since 1 mole of Cl⁻ ions react with 1 mole of Ag; 4.074 moles of Cl⁻ ions will be required to react with 4.074 moles of Ag.

1 L of HCl solution contains 11.53 moles of Cl⁻

Volume of HCl solution that contains 4.074 moles of Cl⁻ = 4.074 * 1L/11.53

Volume of HCl that contains 4.074 moles of Cl⁻ = 0.353 L

Since 1.5 times the amount of precipitating reagent HCl is required, volume of HCl required = 1.5 * 0.353 L

Volume of precipitating reagent HCl required = 0.530 L

Therefore, the volume of precipitating reagent, HCl required to precipitate silver in the form of AgCl from 2,000 g of an alloy containing 22% by weight of Ag is 0.530 L

Learn more about precipitation reactions at: https://brainly.com/question/24944690

Answer:

My lovely people the answer is SOLAR

Explanation:

i just know

The type of energy that uses the photoelectric effect is solar energy. Therefore, the correct option is option B.

When light strikes a material surface, the photoelectric effect takes place, which results in the emission of electrons. Albert Einstein made this intriguing discovery in 1905, and it was essential in the development of quantum physics and our comprehension of the nature of light. The fundamental principle underlying the photoelectric effect is that light is made up of small energy packets known as photons. A photon's energy can be transferred to an electron in a solid or atom when it interacts with those structures. The type of energy that uses the photoelectric effect is solar energy.

Therefore, the correct option is option B.

To know more about photoelectric effect, here:

https://brainly.com/question/33463799

#SPJ6

Answer:

[tex]1.51 \times 1024 \: \: molecules[/tex]

Explanation:

There are 1.51 x 1024 molecules of carbon dioxide in 2.50 moles of carbon dioxide.

Answer:

C. 10.540 moles

Explanation:

divide grams by molar mass to get moles

Explanation:

Mass of one atom of water = Mass of 1 mole / Avogadro's number

Mass of one atom of water = 18g/mol / 6.022×10²³molecules

Mass of one atom of water = 2.989 × 10^-23 g

Mass of glucose = 180(one molecule)

Mass of 100 molecules of glucose = 180×100 =18000

Explanation:

It is claimed that the increases in crop productivity brought about by genetic engineering can help relieve problems faced by farmers by decreasing the losses caused by pests, disease, weeds, and other stressors (Guerinot 2000).

Taking into account the reaction stoichiometry and STP conditions, the volume of nitrogen monoxide gas that is created at STP when 32.2 g of solid copper reacts with excess nitric acid is 7.5677 L.

The balanced reaction is:

3 Cu(s) + 8 HNO₃(aq) → 3 Cu(NO₃)₂ (aq) + 4 H₂O(l) + 2 NO(g)

By reaction stoichiometry, the following amounts of moles of each compound participate in the reaction:

The molar mass of the compounds is:

By reaction stoichiometry, the following mass quantities of each compound participate in the reaction:

The STP conditions refer to the standard temperature and pressure, which values are 0 °C and 1 atmosphere and are reference values for gases. In these conditions 1 mole of any gas occupies an approximate volume of 22.4 liters.

The following rule of three can be applied: if by reaction stoichiometry 190.62 grams of Cu form 2 moles of NO, 32.2 grams of Cu form how many moles of NO?

moles of NO= (32.2 grams of Cu× 2 moles of NO)÷ 190.62 grams of Cu

moles of NO= 0.3378 moles

Then, 0.3378 moles of NO are formed.

Now, you can apply the following rule of three: if by definition of STP conditions 1 mole of NO occupies a volume of 22.4 liters, 0.3378 moles occupies how much volume?

volume= (0.3378 moles× 22.4 L)÷ 1 mole

volume= 7.5677 L

Finally, the volume of NO created is 7.5677 L.

Learn more about the reaction stoichiometry:

brainly.com/question/24741074

#SPJ1

Answer:

448mL AgNO3

Explanation:

M x V

n = 0.230 x .045 = 0.01

2AgNO3 + Na2S --> Ag2S+2NaNO3

1 mol Ag2S --> 2 moles AgNO3

.01 mol Ag2S --> ? moles AgNO3

.01x2/1=.02 moles AgNO3

Moles to L conversion is multiplying by 22.4L so we do .02 x 22.4=0.448L

Then we convert to mL so we multiply by 1000 (1000 x 0.448)

448mL AgNO3

There you go friend, good luck with chemistry :)

Answer:

plastics, Styrofoam, paper, rubber, glass and dry air.

Explanation:

Answer:

c

Explanation:

steel is a good conductor therefore,a steel necklace is your answer

mark my brainliest if i make sense enjoy the rest of your day!

Explanation:

Pressure = Force/Area

therefore,

P = 15/0.00372

= 4.03 X10^³N/m²