Compare and contrast Transverse Waves and Longitudinal Wave

Answer:

I think they should use a bar graph

Explanation:

Because if they use a bar graph they could mark each of the different kind of fertilizer and they could easily see which one affected it the most, either good or bad, by the looking at the heights of the bars to determine your conclusion.

Hi there!

:bar graph:

If they use a bar graph they could mark each of the different kind of fertilizer and they could see easier to tell which one affected it the most, by looking at the heights of the bars to determine the answers.

Answer:

Combustibility is a measure of how easily a substance bursts into flame, through fire or combustion. This is an important property to consider when a substance is used for construction or is being stored. It is also important in processes that produce combustible substances as by product

Answer:chlorine

Explanation:

It’s the answer on the big test

Answer:

Lead

Explanation:

As you move down the periodic table, the elements get larger and gain additional electron shells, increasing the radius.  In order, they are on the table as Chlorine, Selenium, Lead.

Answer:

GAS .assumes the shape and volume of its container

particles can move past one another    

.compressible

lots of free space between particles

.flows easily

particles can move past one another

LIQUID assumes the shape of the part of the container which it occupies

particles can move/slide past one another

.not easily compressible

little free space between particles

.flows easily

particles can move/slide past one another

SOLID .retains a fixed volume and shape

rigid - particles locked into place

.not easily compressible

little free space between particles

.does not flow easily

rigid - particles cannot move/slide past one another

Answer:

See explanation

Explanation:

For elements with atomic numbers 1-10, the arrangement of electrons is as follows; 1s 2s 2p.

These elements are found in the second period that commences at lithium and ends in neon.

The ten electrons that may be found in the atoms of these elements are arranged in orbitals as shown above.

Synesthetes — or people who have synesthesia — may see sounds, taste words or feel a sensation on their skin when they smell certain scents.

I don't know if this helps at all, but i hope it does.

Answer:

opposite

Explanation:

Newtons law explains that for every action force there is an equal and opposite reaction.

Answer:

nope homogeneous

Explanation:

hope this helps :)

Answer:

SOLUTIONS are homogeneous mixtures. A solution is a mixture of two or more substances in a single phase.

Answer:

There are  there are 8.13-10^25

Explanation:

N(CS2)= 1.35* (times) 6.02-10^ 25= 3.13-10^25 molecules

Mole measure the number of elementary entities of a given substance that are present in a given sample. Therefore, 8.12×10²³ molecules are in 1.35 mole of CS[tex]_2[/tex].

The SI unit of amount of substance in chemistry is mole. The mole is used to measure the quantity of amount of substance. It measure the number of elementary entities of a given substance that are present in a given sample. There are so many formula for calculating mole.

we know one mole of any element contains 6.022×10²³ atoms which is also called Avogadro number

number of atoms/molecules=number of moles × 6.022×10²³(Avogadro number)

number of moles of CS[tex]_2[/tex] =  1.35 mol

Substituting all the given values in the above equation, we get

number of atoms/molecules= 1.35 × 6.022×10²³

number of atoms/molecules=8.12×10²³ molecules

Therefore, 8.12×10²³ molecules are in 1.35 mole of CS[tex]_2[/tex].

To know more about mole, here:

https://brainly.com/question/15209553

#SPJ2

Answer:

Loses

Explanation:

liquid changes into solid, heat is released. The energy released upon freezing, known as the enthalpy of fusion, is a latent heat, and is exactly the same as the energy required to melt the same amount of the solid.

Answer:

Matter either loses or absorbs energy when it changes from one state to another. For example, when matter changes from a liquid to a solid, it loses energy. The opposite happens when matter changes from a solid to a liquid. For a solid to change to a liquid, matter must absorb energy from its surroundings.

Explanation:

Answer:

He should use black a light purple brown, tan, blue, and just a tiny bit of pink!

Hope this helps!!

Explanation:

If Johnny wanted to show the brightness of the stars, he should use blue, light blue, yellow, orange, red, and white.

The Milky Way is a huge collection of stars, dust and gas .

Hence , Johnny should use blue, light blue, yellow, orange, red, and white.

Learn more about milky way below

https://brainly.com/question/13956361

#SPJ2

The combination of beads should the student use for  the model :2 green, 3 blue and 12 yellow

In the chemical formula of a compound there are numbers:

1. The number indicates the number of atoms written after the element symbol

2. The number after the parentheses represents the number multiplied by the number of atoms in parentheses.

3. The number before the chemical formula shows the number of molecules behind it, which is usually used in equations

To calculate the beads needed to make a model, we must count the number of atoms of the Al₂(SO₄)₃ molecule

In the Al₂ (SO₄) ₃ molecule there are 3 atoms : Al, S, and O

So the combination of beads

2 green(for Al), 3 blue(for S) and 12 yellow(for O)

Answer:

2 blue, 3 yellow, and 12 green

Explanation:

Answer:

the answer 32/43

Explanation:

The rule of three or is a way of solving problems of proportionality between three known values and an unknown value, establishing a relationship of proportionality between all of them. That is, what is intended with it is to find the fourth term of a proportion knowing the other three. Remember that proportionality is a constant relationship or ratio between different magnitudes.

If the relationship between the magnitudes is direct, that is, when one magnitude increases, so does the other, the direct rule of three must be applied. To solve a direct rule of three, the following formula must be followed:

a ⇒ b

c ⇒ x

So,  

The direct rule of three is the rule applied in this case as follows: If the change in water level is 0.05 inches per hour, what is the change in water level after 24 hours?

change in water level=1.2 inches

To pass a decimal number to a fraction, you must:

Put the decimal number in a fraction above a 1. That is, the decimal number is the numerator, 1 the denominator.

Find an equivalent fraction. That fraction will carry in the denominator a 1, an

Finally, the change in the water level of the pond after 24 hours is 1.2 inches or what is the same  inches

Answer:

+1 Because there are 82 protons.

Explanation:

Answer:

Not 100% sure but...

Explanation:

I know that the second, third and fifth one are correct, not sure if there are any more.

Answer:

1. gas

2. false

Explanation:

Answer: Explanation:

You can change an object's state of matter by adding or removing thermal energy. When you add thermal energy to an object, these things can happen: Particles move faster (increased kinetic energy). Particles get farther apart (increased potential energy).

Answer:

a molecule is defined as an element or compound consisting of two or more atoms held together by chemical bonds

i hope this helps :)

Explanation:

Answer:

It contains more water vapor than cold air

According to the process of conduction which take place from hot to cold end warm saturated air has more water vapor than cold air.

Conduction is defined as a process as a means of which heat is transferred from the hotter end of the body to it's cooler end.Heat flows spontaneously from a body which is hot to a body which is cold.

In the process of conduction,heat flow is within the body and through itself.In solids the conduction of heat is due to the vibrations and collisions of molecules while in liquids and gases it is due to the random motion of the molecules .

As per the concept of conduction, warm hair has more water vapor than cold air, thus the correct option is that warm, saturated air has  more water vapor than cold air.

Learn more about conduction,here:

https://brainly.com/question/31201773

#SPJ6

Answer: A

Explanation:

Answer:

A.Seafloor spreading

Explanation:

Answer:the volume of the liquid increases

Explanation:

Answer:

Option C: Warm temperatures will replace cold temperatures.

Explanation:

In a weather map, a warm front is depicted with a red line and red semi circles while a cold front is depicted with a blue line and blue triangles.

Now, we are told that the map shows a blue line with triangles approaching a red line with semi-circles. This means that the cold front is approaching the warm front.

Now a warm front is simply defined as the transition zone where warm air mass gradually replaces a cold air.

Thus, it means the weather map depicts the fact that warm temperature is replacing cold temperature.

Thus; Option C is correct.

Answer: 1: A cold front moved into the area. 2: It would actually be A. A significant drop in temperature will occur across the area. 3: Movement of large air masses. 4: “A Strong Cold Front Threatens the Region”. 5: a meeting of two air masses with major differences in temperature and moisture.

Hope you got 100 because of this!

Answer:

I'm guessing structure 1

Answer:

no

Explanation:

no

Option C - Electrons are outside the nucleus and and have a negative charge is the correct alternative.

We have electrons.

We have to determine their role inside the atom.

An electron is one of the subatomic particles within an atom. It is negatively charged particle whose magnitude is 1.6 x 10⁻¹⁹ C.

According to the question -

The role of electrons inside the atom is as follows -

Hence, Option C is the correct alternative.

To solve more questions on Atoms, visit the link below-

https://brainly.com/question/2845051

#SPJ2

Answer:

From 4.9 g of sulfuric acid 8.175 g of potassium sulfate is formed.

Explanation:

Given data:

Mass of H₂SO₄ = 4.9 g

Mass of K₂SO₄ formed = ?

Solution:

Chemical reaction:

H₂SO₄ + 2KOH    →    K₂SO₄ + 2H₂O

Number of moles of H₂SO₄:

Number of moles = mass/ molar mass

Number of moles = 4.9 g/ 98.1 g/mol

Number of moles = 0.05 mol

Now we will compare the moles of  H₂SO₄ with  K₂SO₄ .

                       H₂SO₄         :             K₂SO₄

                            1             :                  1

                       0.05           :             0.05

Mass of K₂SO₄:

Mass = number of moles × molar mass

Mass = 0.05 mol × 174.3 g/mol

Mass = 8.715 g

Thus, from 4.9 g of sulfuric acid 8.175 g of potassium sulfate is formed.