1. How does the figure below illustrate Hund's rule?

Answer: Its C, c is a solid state

the answer :

Hi there !

The answer is "C"

; due to the intermolecular forces of attraction

[tex]\huge{\underline{\underline{\boxed{\sf{\purple{ǫᴜᴇsᴛɪᴏɴ}}}}}}[/tex]

[tex]\huge\fcolorbox{aqua}{lime}{Answer}[/tex]

[tex]\huge{\underline{\underline{\boxed{\sf{\purple{Explanation}}}}}}[/tex]

➡PV = nRT

➡PV = (W/M)RT

➡PM = (W/V)RT

➡PM = PRT

➡P = pRT/M

➡P = 2.85 × 0.082 x 298 / 44

➡P = 1.583 atm

➡P = 1.583 × 760

➡P = 1203 mm Hg

Hope this helps you:)

Answer:

The Moon has an atmosphere.

Explanation:

The Moon has an atmosphere, but it is very tenuous. Gases in the lunar atmosphere are easily lost to space. Because of the Moon's low gravity, light atoms such as helium receive enough energy from solar heating so that they escape in just a few hours.

Electrolysis is a technique that separates natural elements. It is commercially used to obtain important materials (e.g., pure metals) for construction.

Electrolysis refers to the use of an electric current to trigger non-spontaneous chemical reactions.

This technology (electrolysis) is commercially important in industry, construction and therefore also in architecture in order to extract metals and minerals from the ground.

Electrolysis uses particular electrolytic cells in order to extract highly pure metals from ores.

Learn more about electrolysis here:

https://brainly.com/question/12054569

Answer: Electrolysis is a technique that separates natural elements. It is commercially used to obtain important materials (e.g., pure metals) for construction.

Electrolysis refers to the use of an electric current to trigger non-spontaneous chemical reactions.

This technology (electrolysis) is commercially important in industry, construction and therefore also in architecture in order to extract metals and minerals from the ground.

Electrolysis uses particular electrolytic cells in order to extract highly pure metals from ores.

Learn more about electrolysis here:

brainly.com/question/12054569

Answer:

There are 27 Valence electrons : )

4+1+1+1+6+4+1+1+4+1+1+1 is 27

Explanation:

There are a total of [5×1]+[2×4]+[7]=21[5×1]+[2 × 4 ] + [ 7]=21 valence electrons

Considering the Dalton's partial pressure, the correct answer is option a.: the total pressure of the mixture is 1.86 atm.

The pressure exerted by a particular gas in a mixture is known as its partial pressure. So, Dalton's law states that the total pressure of a gas mixture is equal to the sum of the pressures that each gas would exert if it were alone:

[tex]P_{T} =P_{1} +P_{2} +...+P_{n}[/tex]

where n is the amount of gases present in the sample.

This relationship is due to the assumption that there are no attractive forces between the gases.

In this case, a mixture contains 220 mmHg of CO, 350 mmHg of Ne and 840 mmHg of He. The total pressure of the mixture can be calculated as:

[tex]P_{T} =P_{CO} +P_{Ne} +P_{He}[/tex]

[tex]P_{T} =220 mmHg +350 mmHg+840 mmHg[/tex]

Solving:

[tex]P_{T}[/tex]= 1410 mmHg

Being 760 mmHg=1 atm, then:

[tex]P_{T}=1410 mmHgx\frac{1 atm}{760 mmHg}[/tex]

Solving:

[tex]P_{T}[/tex]= 1.86 atm

Finally, the correct answer is option a.: the total pressure of the mixture is 1.86 atm.

Learn more:

Answer:

About 7.0 × 10³ J or 7.0 kJ

Explanation:

We want to determine the amount of energy needed to raise the temperature of 67 grams of water from 20°C to 45°C.

We can use the heat equation:

[tex]\displaystyle q = mC\Delta T[/tex]

Where C is the specific heat of water.

Substitute and evaluate:

[tex]\displaystyle \begin{aligned} q & = (67\text{ g})\left(\frac{4.2\text{ J}}{\text{g-$^\circ$C}}\right)\left(45^\circ \text{ C}- 20.^\circ\text{ C}\right) \\ \\ & = (67\text{ g})\left(\frac{4.2\text{ J}}{\text{g-$^\circ$C}}\right)(25^\circ \text{ C}) \\ \\ & = 7.0\times 10^3 \text{ J}\end{aligned}[/tex]

Recall that there are 1000 J in a kJ. Hence:

[tex]\displaystyle \begin{aligned} q & = 7.0\times 10^3 \text{ J} \cdot \frac{1\text{ kJ}}{1000\text{ J}} \\ \\ & = 7.0 \text{ kJ}\end{aligned}[/tex]

In conclusion, it will take about 7.0 × 10³ J or 7.0 kJ of energy to raise the temperature of 67 grams of water from 20 °C to 45 °C.

Answer:

liquid and gas........................

Answer:

Explanation: Atomic weight is measured in atomic mass units (amu), also called daltons.

Covalent compounds are generally not very hard because they are formed by two or more nonmetallic atoms.

Covalent compounds are compounds whose constituent elements are joined together by covalent bonds.

Covalent bonding occurs when two or more nonmetallic atoms of an element share valence electrons. This means that covalent compounds will not be physically hard since they constitute non-metals.

Examples of covalent compounds are:

Learn more about covalent compounds at: https://brainly.com/question/21505413

Answer:

It depends on their melting and/or their boiling points, because the heat provides the particles with kinetic energy to break the electrosatic bonds in the substances, which can differ in strength

Explanation:

Answer:

Water will generally require more energy for a phase change compared to a similar substance without hydrogen bonds.

Explanation:

Answer:

D

Explanation:

The valence electrons are the outer electrons and must be located in the outermost shell. In this case, D.

Answer:it's b hope that help

The molar mass of water is 18 g. Given that there are 0.23 teaspoon for every 1 g. Thus , for 18 g there would be 4.14 teaspoons.

Any substance that contains  6.022 × 10²³ number of atoms is called one mole of that substance. The mass of a compound or molecule containing these much atoms is called its molar mass.

Molar mass of water is 18 g. Thus, it means that one mole of water weighs 18 g. Given that for every 1 g of water there are 0.23 teaspoon. Thus, number of teaspoons for one mole or 18 g of water is:

number of teaspoons = 18 g × 0.23  /1 g

                                    = 4.14 teaspoons.

Therefore, 4.14 teaspoons are required for one mole of water.

To find more on molar mass, refer here:

https://brainly.com/question/12127540

#SPJ6

Answer:

10.53m/s

Explanation:

Initial velocity: 13m/s

Angle of projection: 55deg

Y-component of velocity is given as usin⌀

Plugging in, we get

= 13 * sin(55deg)

= 13 * 0.81

= 10.53

⇒ 10.53m/s

The number of moles of the solute in the solution is the product of its volume and molarity. The number of moles of copper sulphate in 0.500 L of 2.30 M solution is 1.15 moles.

Molarity of a solution is the common term used to represent the concentration of a solution. It is the ratio of its number of moles of solute to the volume of solution in liters.

Molarity = no.of moles/volume in L.

Molarity is a temperature dependant quantity.

The given solution has a volume of 0.500 L.

molarity of copper sulphate solution = 2.30 M

Thus, number of moles of copper sulphate solute dissolved in 0.50 L of water is calculated by multiplying the volume with molarity.

No. of. moles of copper sulphate = molarity × volume

= 0.500 L × 2.30 M = 1.15 moles.

Therefore, there will be 1.15 moles of copper sulphate in the solution.

To find more on molarity, refer here;

https://brainly.in/question/9793108

#SPJ2

Answer:

Ca = 40.1 g

Cl = 35.5

40.1 + 35.5×2

40.1 + 71

111.1 g

Answer:    World 5,306,425,000 6,895,889,000 7,503,828,180

1 China 1,139,060,000 1,341,335,000 1,384,688,986

2 India 873,785,000 1,224,614,000 1,296,834,042

3 United States 253,339,000 310,384,000 329,256,465

Explanation:

Very Very sorry

Answer:

55 centimeters

Explanation:

20+15+25

Answer:

Explanation:

AND REMEMBER DO ALWAYS READ AND WRITE

Answer:

Q= ms∆T

Where, m is mass of substance

S is specific heat

∆T is temperature change

As in question , m=8.21 ,s=0.13 ,∆T =6.2

So, Q = 8.21×0.13×6.2=6.61 J

i think it's a simple covalent structure

According to Dalton's atomic theory, atoms of different elements combine in simple whole-number ratios to form compounds.

As the name implies, Dalton's atomic theory is a theory proposed by an English scientist named John Dalton in the 1900's.

The Dalton's atomic theory is composed of five main parts, which are as follows:

Therefore, in accordance to Dalton's atomic theory, atoms of different elements combine in simple whole-number ratios to form compounds.

Learn more about Dalton's atomic theory at: https://brainly.com/question/13157325?referrer=searchResults

Answer:

A- Dry with low humidity

Explanation:

The hydrosphere includes the water which is on the surface of the earth, below the ground and in the air.  

On analyzing the climatic conditions in the tropics due to the interaction of the atmosphere and hydrosphere, the presence of water droplets in tropics is less resulting in less humidity and, thus the climatic condition is dry.

Therefore the climatic condition that is typically found in tropics due to interaction of the atmosphere and hydrosphere is dry with low humidity.

Hope this helps!

The replacement reaction will not occur because iodine is less reactive than chlorine.

A replacement reaction is a type of reaction in which one element is replaced by another in a compound.

The principle behind one element replacing the other is based on the reactivity of an element. A more reactive element will displace a less reactive one.

According to this question, the following displacement reaction is given: MgCl2 + I2 → ?

This reaction will not occur because chlorine is more reactive/electronegative than iodine, hence, iodine cannot displace it.

Learn more about replacement reaction: https://brainly.com/question/8625202?referrer=searchResults

I believe the answer would be D